On 5/3/2012 8:40 PM, Carl wrote:
> Used a Bosuns knife in the navy and a linoleum knife at home.
> RG-8/213 is mil spec rated at 5000V and easily handles 10KV so I wouldnt
> stain my undies with a little knick.
That's the advantage of that old tried and true coax. With many of the
new LMR and CNT cables you have to carefully score the jacket and then
break it. I think you could ruin the braid with a rough fingernail.
73
Roger (K8RI)
>
> Carl
> KM1H
>
>
>
>
> ----- Original Message -----
> From:<donroden@hiwaay.net>
> To:<amps@contesting.com>
> Sent: Thursday, May 03, 2012 6:40 PM
> Subject: Re: [Amps] Fwd: Re: soldering vs crimping
>
>
>> We were poor and had to use a single edge razor blade to lightly score the
>> braid-solder before breaking it off.
>>
>> Don W4DNR
>>
>>
>> Quoting Alek Petkovic<vk6apk@bigpond.com>
>>
>>> Bad move. Don't do it.
>>>
>>> By using the tubing cutter, you are certainly doing a neat job but you
>>> are deforming that soldered braid and pushing it, as a sharp edge,
>>> inwards, through the dielectric towards the centre conductor.
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>> Version: 10.0.1424 / Virus Database: 2411/4976 - Release Date: 05/03/12
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|