On 12/24/2010 2:16 PM, Carl wrote:
> I thought you were supposed to mount the cover to the chassis and
> screw in place, eliminates making clips (-;
>
> And Roger, how about adding some space between the post and your
> replies, its often all jumbled together and a prime candidate for the
> Delete key.
>
Ahhh...What seems to be missing. They are completely separated in my
reader by offset and attribute lines.
This answer goes to the left margin, yours has a blue line at the left
margin delineating it from this answer. Each of the previous posts
included is also outlined by an indented and distinctly colored left
margin. I answer in the format of the previous posts or do you remove
all formatting?
> Carl
>
>
> ----- Original Message ----- From: "Roger (K8RI)"
> <sub1@rogerhalstead.com>
> To: <amps@contesting.com>
> Sent: Friday, December 24, 2010 1:25 PM
> Subject: Re: [Amps] Cracked Chimney
>
>
>>
>>
>> On 12/24/2010 1:21 PM, mike stokes wrote:
>>> KJ9D (SK) built a few Home Brew 4-1000 Amps and he cut the top and
>>> bottom
>>> out of large pickle Jars. They wokred fine,
>> I had completely forgot about that.
>> And you have the curve in at the top if done carefully.
>>
>> Use the "hot wire" to cut and a fine emery cloth to *carefully* get rid
>> of the sharp edges.
>> It's a relatively simple procedure, but still may take a bit of practice
>> if not having done it before.
>>
>> 73
>>
>> Roger (K8RI)
>>> 73
>>> Mike
>>> KK9V
>>>
>>> On Fri, Dec 24, 2010 at 9:27 AM, Wayne Rogers<n1wr@chesapeake.net>
>>> wrote:
>>>
>>>> I have managed to put a crack in my chimney (SK-506 for 4-1000
>>>> etc). The
>>>> crack is such that I am afraid that even the pressure from the
>>>> metal clips
>>>> will cause a large piece of the glass to break off.
>>>>
>>>> Has anyone had any luck either repairing such a crack or having a
>>>> glass
>>>> repair firm do it? I have looked around for some such repair
>>>> service, but
>>>> have not had any luck. I was hoping to find someone that repairs
>>>> antique
>>>> glass. I would think that in the right hands the glass could be
>>>> heated and
>>>> re-joined?
>>>>
>>>> As these chimneys are getting scarce I'd like to repair this one -
>>>> but I'm
>>>> probably looking at a cost equal or greater than what I can pay for a
>>>> replacement. Any thoughts?
>>>>
>>>> Merry Christmas to all.
>>>> Wayne N1WR
>>>>
>>>> _______________________________________________
>>>> Amps mailing list
>>>> Amps@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/amps
>>>>
>>>
>>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|