On 12/24/2010 1:21 PM, mike stokes wrote:
> KJ9D (SK) built a few Home Brew 4-1000 Amps and he cut the top and bottom
> out of large pickle Jars. They wokred fine,
I had completely forgot about that.
And you have the curve in at the top if done carefully.
Use the "hot wire" to cut and a fine emery cloth to *carefully* get rid
of the sharp edges.
It's a relatively simple procedure, but still may take a bit of practice
if not having done it before.
73
Roger (K8RI)
> 73
> Mike
> KK9V
>
> On Fri, Dec 24, 2010 at 9:27 AM, Wayne Rogers<n1wr@chesapeake.net> wrote:
>
>> I have managed to put a crack in my chimney (SK-506 for 4-1000 etc). The
>> crack is such that I am afraid that even the pressure from the metal clips
>> will cause a large piece of the glass to break off.
>>
>> Has anyone had any luck either repairing such a crack or having a glass
>> repair firm do it? I have looked around for some such repair service, but
>> have not had any luck. I was hoping to find someone that repairs antique
>> glass. I would think that in the right hands the glass could be heated and
>> re-joined?
>>
>> As these chimneys are getting scarce I'd like to repair this one - but I'm
>> probably looking at a cost equal or greater than what I can pay for a
>> replacement. Any thoughts?
>>
>> Merry Christmas to all.
>> Wayne N1WR
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|