In a message dated 12/23/2010 7:00:40 A.M. Eastern Standard Time,
TexasRF@aol.com writes:
When tuning I run the LOAD cap up to 10 (MAX)
I am not completely familiar with the Centurian, but most amplifiers number
their load controls from 1 to 10 and from left to right. That being the
case, the maximum load value (in pf) should be 1 and not 10. So usually
on the lower bands where more load C is needed the control would be much
lower than 10. So based on the above statement, can you explain how what you
said is true? Thanks Lou
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|