Try the Stepan Company. They used to manufacture a few kinds of silver epoxy
years ago
Alex 4Z5KS
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Carl
Sent: Thursday, May 28, 2009 2:05 AM
To: Herzog; Ham-amps
Subject: Re: [Amps] Silver epoxy yes
Silver epoxy is still around. We used it to seal microwave modules prior to
going in the oven were it was cured and the modules then final tested and
shipped.
Carl
KM1H
----- Original Message -----
From: "Herzog" <herzog@frontiernet.net>
To: "Ham-amps" <amps@contesting.com>
Sent: Wednesday, May 27, 2009 9:16 PM
Subject: [Amps] Silver epoxy yes
> RE: n Wed, May 27, 2009 at 10:44:44AM -0500, Roy wrote:
> > > "The piece that broke off fits into a well about 1/2" deep. No iron
> I have
> > > will reach it."
> > >
> > > 73, Dick, W1KSZ
> =========
> 25 years ago, there was a silver epoxy, that is silver particles in the
> mix. We had a broken capacitor like that, and a brighit tech tried
> "epoxy-ing" it. The thing worked. It had poor clading as built, hence
> the failure. It carried 100 amperes RF at 30 MHz. I am still amazed.
> K2LB
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|