Amps
[Top] [All Lists]

Re: [Amps] Cutting G-10 Board

To: amps@contesting.com
Subject: Re: [Amps] Cutting G-10 Board
From: Steve Thompson <g8gsq@eltac.co.uk>
Date: Wed, 30 Aug 2006 11:17:39 +0100
List-post: <mailto:amps@contesting.com>

Bob Maser wrote:
> Does anyone has advice on how to make straight cuts on 1/8" G-10 board 
> material(actually, it is G-11 but very close to being the same as G-10)?  I 
> am building a plenum for a MLA-2500 and want straight cuts to allow for 
> minimum air gaps in the joints.
If there's a pcb shop local to you, ask nicely if they will do some cuts 
on their guillotine. A few coins in the coffee fund is often enough 
payment. Their scrap bin is a good source of material too.

Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>