[Amps] Cutting G-10 Board

["Bob Maser" <bmaser@tampabay.rr.com>]

Does anyone has advice on how to make straight cuts on 1/8" G-10 board 
material(actually, it is G-11 but very close to being the same as G-10)?  I 
am building a plenum for a MLA-2500 and want straight cuts to allow for 
minimum air gaps in the joints.

Thanks

Bob  W6TR 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps