Amps
[Top] [All Lists]

Re: [Amps] Cutting G-10 Board

To: AMPS <amps@contesting.com>
Subject: Re: [Amps] Cutting G-10 Board
From: Tony King - W4ZT <amps080906@w4zt.com>
Date: Tue, 29 Aug 2006 17:20:41 -0400
List-post: <mailto:amps@contesting.com>
I have a non ferrous metal cutting blade for my table saw and cut 
circuit board and aluminum sheet on it all the time. Be very careful not 
to bind the outfeed against the fence. Kickback from metal or G-10 can 
be horrid.

73, Tony W4ZT


Bob Maser wrote:
> Does anyone has advice on how to make straight cuts on 1/8" G-10 board 
> material(actually, it is G-11 but very close to being the same as G-10)?  I 
> am building a plenum for a MLA-2500 and want straight cuts to allow for 
> minimum air gaps in the joints.
> 
> Thanks
> 
> Bob  W6TR 
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>