ORIGINAL MESSAGE:
On Fri, 04 Aug 2006 19:03:23 -0400, you wrote:
>Keep your leads short and using
>a thin copper strap around the anode cooler to make your connection to
>the plate choke will help in that regard.
------------ REPLY SEPARATOR ------------
I wondered about this. Why connect to the cooling fins when you can
easily connect directly to the anode itself? I just made the
connection to a lug under the screw that holds the fins on and so far,
so good.
I haven't had it on the air yet, but into a dummy load it does fine.
Hope to have it on the air in the next week or so.
Bill, W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|