George,
I forgot to put the number of the digitizing plug-in, it's a 7D20. Below is
some specs from a website about Tek scopes;
Adds digital storage capability to TEK 7000 series mainframes. Fully GPIB
programmable. 70 MHz for repetitive signals, Sample rate: 40 MHz. Dual input
channels. Six waveform storage. Enveloping and signal averaging.
Digital Storage for 7000 series ainframe
70 Mhz bandwidth for repetitive Signals
10 Mhz Single Shot Bandwidth
Two channels Simultaneous Acquisition
Totally Progarmmable Storage of Six independant waveforms
Enveloping and signal averging
Cursor Measurements
Pretrigger and post trigger
The 7D20 Programmable Digitizer Plug-In is a GPIB programmable plug-in that is
compatible with all 7000 Series mainframes (including the USM 281C) except the
7104. When combined with a 7000 Series mainframe, this plug-in creates a fully
programmable, digitizing oscilloscope. The unit can accurately measure the
amplitude of a 50 ns wide transient event. 70MHz Bandwidth for Repetitive
Signals 10MHz Single-Shot Bandwidth Dual Channel Simultaneous Acquisition.
The Tektronix 7D20 is a GPIB-Programmable Digitizer plug-in for Tektronix
7000-series oscilloscope mainframes. It performs simultaneous sampling on both
of its' input channels, with 70 MHz bandwidth for repetitive signals, and 10
MHz BW for single-shot events. Other features include:
Digital storage of six waveforms
Storage and recall of six setups
Two cursors for waveform measurement functions
Waveform averaging
Complete programmability via GPIB
Info and photo available here;
http://www.barrytech.com/tektronix/tek7000/tek7d20.html
Best,
Will
*********** REPLY SEPARATOR ***********
On 3/26/06 at 5:05 PM exray@bellsouth.net wrote:
>Will,
>
>I know of no plug-in that makes this a "Digital" storage scope. The unit is
>an analog storage scope . The CRT is the storage medium. This has several
>advantages not the least of which is it's ability to capture a glitch. And
>it's really good for video which most digital types are NOT!
>
>The CRT is very expensive if you can find one....so keep the intensity down
>as much as possible.
>
>Enjoy,
>George
>
>
>----- Original Message -----
>From: "Will Matney" <craxd1@verizon.net>
>To: <amps@contesting.com>
>Sent: Sunday, March 26, 2006 1:01 PM
>Subject: Re: [Amps] Tek Scope
>
>
>> George, it has two 7A18 vertical amps, and one 7B53 time base as it is. I
>bought a 7A26 vertical to bring it up to its full potential of 100 MHz. The
>7A18 is an 80 MHz vertical plug-in, and the 7A26 a 200 MHz. In this case,
>the 7A26 will only be usable up to 100 MHz due to the scope being 100 MHz I
>would think.
>>
>> Best,
>>
>> Will
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 3/26/06 at 12:48 PM exray@bellsouth.net wrote:
>>
>> >Most Tek plug-ins have a number. Could give info if I knew which number.
>> >
>> >George
>> >W4IW
>> >
>> >----- Original Message -----
>> >From: "Will Matney" <craxd1@verizon.net>
>> >To: <amps@contesting.com>
>> >Sent: Saturday, March 25, 2006 11:35 PM
>> >Subject: [Amps] Tek Scope
>> >
>> >
>> >> All,
>> >>
>> >> I finally broke down and bought a Tek 7633 ( 100 MHz DSO ) with the
>> >plug-ins. I bought a 200 Mhz dual trace vertical amp plug-in to replace
>one
>> >80 MHz one that's in it. I'm wondering if any have used the digital
>plug-in
>> >which makes it a digital scope? This is the plug-in that takes up all
>three
>> >bays, and is a one plug-in deal. I primarly bought it with the intention
>of
>> >buying a spectrum analyzer and tracking generator plugin later on. Now
>> >though, I'm wondering about the digital plug-in. The plugins in it are a
>> >delayed time base, and two dual trace vertical plugins, both 80 MHz. The
>> >one
>> >vertical was damaged, mostly a couple of knobs so I bought a 200 MHz to
>get
>> >the full use out of the scope. It will still have the one 80 MHz in it
>> >which
>> >is good. Any comments on the 7633 scope would be appreciated.
>> >>
>> >> Best,
>> >>
>> >> Will
>> >>
>> >> _______________________________________________
>> >> Amps mailing list
>> >> Amps@contesting.com
>> >> http://lists.contesting.com/mailman/listinfo/amps
>> >>
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|