All,
This is a simple balun question. I wish to make a 100 watt 50 Ohm to
about 25 Ohm balun for 2 to 50 MHz, I realize that spread may be too
large and both ends may not perform well. The input is coax and the
output is effectively a dipole.
What core material should I select? (I believe 43)
About what OD diameter core?
How many windings should be on the 50 Ohm side?
How many windings should be on the 25 Ohm side?
Should this be wound as independent windings or as an autotransformer?
I have tried to make a balun with 'red' cores with 10 windings on the
input and 7 on the output. This does not behave well at all. There is
some signal at the output however impedance measurements are very strange.
Thanks in advance - Dan
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|