Does anyone know if there is a way to test 572 B's?
I recently acquired this AMP. It had "fairly new tubes" -- according to the
previous
owner perhaps 20-30 hours on them. I found I was unable to load it up to more
than 400-600W
output and suspected the 500 pf plate bypass cap (which a couple of you
mentioned as a possible
problem). I replaced the plate bypass cap, with a .001 mfd and added a .01 mfd
in parallel.
Then I replaced the plate RF choke with a new choke from RF parts designed for
use in
Ameritron and other amps (it specs at 1.5A, 225 uH, 4 KV max). Then I put it
all back
together and fired it up and the power output is pretty much the same as before
I
made the changes.
So I am wondering if the TUBES might be a little soft.
Anyone have any other ideas??
Please and thanks and best 73 de alan
--
Alan Kaul W6RCL LaCanada, CA 91011
e-mail: w6rcl@amsat.org
http://
home.att.net/~alan.kaul/index.html
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|