> Shortly after the first article on parasitic suppression was published in
> the October 1988 issue of *QST*, Ten Tec reportedly tried using low
> VHF-Q/low VHF-Rp parasitic suppressors. However, during 28MHz operation,
> the Ten Tec engineers observed signs of heating in the VHF suppressors,
> so they went back to using their conventional suppressor design, which
> ran cooler at 28MHz
Actually two manufacturers tried and abandoned the nichrome. Neither
manufacturer noted any improvement in field service. The Ten Tec tube
problems were related to the lack of grid protection, and operators
bumping the grid's too hard.
It's my understanding Ten Tec's later amps included an electronic
overload to protect the grids, and that improved tube life by
preventing destructive operator error.
The grid dissipation limit of a 3CX800 is reached at about 130 mA per
pair of tubes. Gold migration increases rapidly as you approach that
limit, and eventually can cause a tube arc.
73, Tom W8JI
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|