Thanks for the info. I found a copy of the manual online which says to connect
Pin 4 to the + T/R of the linear and Pin 3 to ground.
For QSK, the text says to jump pin 8 to pin 3.
However, the diagram says Pin 8 to pin 5.
Rich NN3W
>
> From: "Joe Subich, W4TV" <k4ik@subich.com>
> Date: 2006/01/13 Fri PM 02:18:16 EST
> To: "'Richard DiDonna'" <nn3w@cox.net>,
> <Yaesu@contesting.com>
> Subject: RE: [Yaesu] FT-990 linear connections
>
>
> Rich,
>
> This FT-1000MP information is applicable to the FT-990:
> http://www.qsl.net/n1eu/Yaesu/MPAcom.htm
>
> 73,
>
> ... Joe, W4TV
>
>
>
> > -----Original Message-----
> > From: yaesu-bounces@contesting.com
> > [mailto:yaesu-bounces@contesting.com] On Behalf Of Richard DiDonna
> > Sent: Friday, January 13, 2006 12:37 PM
> > To: yaesu@contesting.com
> > Subject: [Yaesu] FT-990 linear connections
> >
> >
> > I'm wiring up a DIN plug to connect a FT-990 to an AL80A (a
> > full QSK linear). Ive connected the neutral and hot pins.
> > However, IIRC, the manual states that you connect Pin 3 and
> > pin 8 with a jumper. The diagram appears to show pin 8 to pin 5.
> >
> > Which are the correct pins to use?
> >
> > 73 Rich NN3W
> >
> > _______________________________________________
> > Yaesu mailing list
> > Yaesu@contesting.com
> > http://lists.contesting.com/mailman/listinfo/yaesu
> >
> >
>
>
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|