Yes, I use quite a bit of LMR-600, a very nice 1/2" cable. You will need the H4
piston crimper - I borrowed one from the local cable/tower guy. I run LMR-600
from the SPG to the tower, then Bury-Flex up the tower and in close to the
radios. I've used both crimp and clamp and prefer crimp.
73, Jamie
WB4YDL
Sent from my iPad
> On Jun 4, 2015, at 6:28 AM, Richard Thorne <rthorne@rthorne.net> wrote:
>
> I'm going to replace all of the RG213 coax on my current tower with LMR-600.
> I've been researching connectors.
>
> Looks like there are two varieties, crimp and clamp connectors. After
> watching a few you tube videos of the installation process of both, I'm
> leaning towards the crimp type. It does require a good crimp tool, but it
> looks a little more robust than the clamp variety.
>
> Any opinions out there if one is better than the other?
>
> Thanks
>
> Rich - N5ZC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|