I dunno about the LMR600uf, but the jacket on the LMR400uf is reportedly very
fragile. Have you considered BuryFlex all the way?
73, Mike NF4L
> On Jun 4, 2015, at 12:58 PM, Richard Thorne <rthorne@rthorne.net> wrote:
>
> John,
>
> You definitely need a more flexible coax for rotor loops. I'll either use a
> short length of RG-213, but more than likely will track down some LMR-600uf
> which is the flexible version.
>
> Rich - N5ZC
>
> On 6/4/2015 8:19 AM, john@kk9a.com wrote:
>> I am not familiar with this cable, can it run directly to the antenna or
>> do you need a different cable for the rotator loop?
>>
>> John KK9A
>>
>>
>> To: Towertalk <towertalk@contesting.com>
>> Subject: [TowerTalk] LMR-600: Crimp or Clamp Connectors?
>> From: Richard Thorne <rthorne@rthorne.net>
>> Date: Thu, 04 Jun 2015 06:28:41 -0500
>>
>>
>> I'm going to replace all of the RG213 coax on my current tower with
>> LMR-600. I've been researching connectors.
>>
>> Looks like there are two varieties, crimp and clamp connectors. After
>> watching a few you tube videos of the installation process of both, I'm
>> leaning towards the crimp type. It does require a good crimp tool, but it
>> looks a little more robust than the clamp variety.
>>
>> Any opinions out there if one is better than the other?
>>
>> Thanks
>>
>> Rich - N5ZC
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|