I have read information from a credible source that properly done crimp
connections actually cold weld the materials together and are superior
to soldering. While not a direct answer to your question it makes me
lean toward the crimp solution.
Patrick
On 6/4/2015 6:28 AM, Richard Thorne wrote:
I'm going to replace all of the RG213 coax on my current tower with
LMR-600. I've been researching connectors.
Looks like there are two varieties, crimp and clamp connectors. After
watching a few you tube videos of the installation process of both,
I'm leaning towards the crimp type. It does require a good crimp
tool, but it looks a little more robust than the clamp variety.
Any opinions out there if one is better than the other?
Thanks
Rich - N5ZC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|