| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] omni 6 |
| From: | JOHN <ku3g@yahoo.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 10 Oct 2013 07:06:45 -0700 (PDT) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
good morning gang I have an omni 6 runing n3fjp softwave , i am using a w1gee interface from the computer to the ci/v jack on the rear of the omni , control of the rig is fine, however i can not send cw , i am almost 99% sure i did this in the past , any ideas would be appreciated 73 john ku3g _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] (no subject), JOHN |
|---|---|
| Next by Date: | Re: [TenTec] omni 6, John Huffman |
| Previous by Thread: | Re: [TenTec] omni 6, GARY HUBER |
| Next by Thread: | Re: [TenTec] omni 6, John Huffman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |