That's the radio for me! Someday I hope to find a nice one in good condition. I
was thinking of going in on the board purchase just in case I find a nice one
without a working display.
Sent from my iPhone
On Sep 6, 2011, at 2:40 PM, "Jerry Haigwood" <jerry@w5jh.net> wrote:
> Curt,
> The Corsair II only uses the microcontroller to display the frequency
> and to do the keying. It really does not control anything. The Corsair II
> still uses the "old" PTO, crystal filters, audio filter WITHOUT DSP, etc. I
> think it is the last of the TenTec analog radios.
> Jerry W5JH
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Hulett, Russell
> Sent: Tuesday, September 06, 2011 1:32 PM
> To: TenTec@contesting.com
> Subject: [TenTec] Last Ten-Tec to NOT use Microprocessor?
>
> The discussion about Corsair II replacement logic board prompts a question.
> What was the last model that didn't use a microprocessor for control? The
> Corsair or the Omni C or ?
>
> 73, Curt KB5JO
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|