Curt,
The Corsair II only uses the microcontroller to display the frequency
and to do the keying. It really does not control anything. The Corsair II
still uses the "old" PTO, crystal filters, audio filter WITHOUT DSP, etc. I
think it is the last of the TenTec analog radios.
Jerry W5JH
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Hulett, Russell
Sent: Tuesday, September 06, 2011 1:32 PM
To: TenTec@contesting.com
Subject: [TenTec] Last Ten-Tec to NOT use Microprocessor?
The discussion about Corsair II replacement logic board prompts a question.
What was the last model that didn't use a microprocessor for control? The
Corsair or the Omni C or ?
73, Curt KB5JO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|