I designed my board and firmware to be a simple "drop in" replacement
for the Corsair II mpu board. It interfaces to a display driver board
which is unique to the Corsair II. So no - it can't be used with any
other TT radio.
Of course you can apply the same technique to other TT radios, but it
would need a major re-write of the firmware and possibly some hardware
changes.
Steve G3TXQ
On 06/09/2011 22:43, Hulett, Russell wrote:
> Somehow I had the evidently wrong impression that the earlier displays like
> for the Omni C used TTL chips still readily available. Upon review of the
> schematic for my 544, the MK50398N chip is mentioned. I haven't looked at
> the Omni D-B yet. Is the replacement discussed for the Corsair II also a
> potential replacement for earlier Ten Tec digital displays?
>
> 73, Curt KB5JO
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|