Kevin,
Thanks for the ideas. The chip in the PigKnob looks like a MAX3232 and I
might explore that a little more. Yes, I see a serial converter available
for $90 (that might be the simplest option).
I tried TR 6,79, 6,81, 6,83, 6.94, 6.96 and 7.00 and none would to work at
9600. I am slightly exploring hardware control because it looks like TR is
handling the data sent to it. I am going to try a local network guy for
help.
Mike W9RE
-----Original Message-----
From: Kevin Schmidt [mailto:w9cf@arrl.net]
Sent: May 22, 2013 10:01 PM
To: Mike Wetzel
Cc: trlog@contesting.com
Subject: Re: [Trlog] TR Baud Rate-Update
Mike,
I have 2 possible suggestions. Neither very good.
1. If you have a spare computer with 2 serial ports or 2 USB to serial
port adapters, you could set it up as a baudrate converter. A linux
box with ports /dev/ttyS0 and /dev/ttyS1 could use a script with the
lines like:
stty -F /dev/ttyS0 4800
stty -F /dev/ttyS1 9600
cat < /dev/ttyS0 > /dev/ttyS1 &
cat < /dev/ttyS1 > /dev/ttyS0
to link the two com ports together.
I don't know how this is done in Windows, but there must be an equally
simple way there. There are also baudrate converter boxes that you can buy.
2. I believe the linux version of TR supports any baud rate as long as
the actual amount of data sent is not too large. That is, the TR routines
run at the same speed as in DOS TR, but the linux kernel handles all the
serial port i/o and buffers it. The actual amount of data that TR sends
and receives is very small. However, you almost certainly don't want to
try out alpha level software for the first time the day before a major
contest. I haven't been able to test this directly since I only have a K2
which is fixed at 4800 baud. I have done a test with a script like that
above communicating with the K2 at 4800 baud, but with TR communicating
to a pseudotty at 9600, 38400, 57600, and 115200 baud, and it works fine.
73 Kevin w9cf
On Tue, May 21, 2013 at 04:00:27PM -0400, Mike Wetzel wrote:
> I got the Pigknob configured to 9600 baud (lowest it will go) but TR won't
> exactly work with 9600. I can type in a freq in TR and the radio goes
there
> but TR just shows the correct 'band i.e. 40' but not the mode (shows a
'?')
> and shows the wrong frequency or no frequency. When I change the frequency
> on the radio TR does not show the correct band but just the previous one.
> This happens on both my radios a K3 and a IC-7800. Tree mentioned turning
on
> IRQ's in TR but I cannot find that option.
>
> I have determined (assumed) that since I could communicate with the
Pigknob
> at 38400 that my serial cards are ok at 9600.
>
> Any ideas-thanks,
>
> Mike W9RE
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|