In my setup all of a sudden at 9600 I see a frequency on TR that sometimes
follows the radio but is off by a few KHz. The radio follows a direct freq
entry in TR (every time) but the freq readout in TR does not update nor does
the band update.
Any ideas?
Mike W9RE
-----Original Message-----
From: Trlog [mailto:trlog-bounces@contesting.com] On Behalf Of Mike Wetzel
Sent: May 21, 2013 12:04 PM
To: Trlog@contesting.com
Subject: [Trlog] TR Baud Rate
Is anyone using TR with a baud rate of 9600 or higher? I can't seem to get
9600 to work and wondering if it is my computer, serial card or TR. I am
trying to get a PigKnob to work with a K3 and TR, and the PigKnob only goes
down to 9600.
Thanks,
Mike W9RE
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|