How does the pigknob work? Is it between the radio and computer on the serial
line?
Does it work with other software at 9600 baud?
--
George Fremin III
geoiii@kkn.net
On May 21, 2013, at 11:14 AM, "Mike Wetzel" <mjwetzel@comcast.net> wrote:
> In my setup all of a sudden at 9600 I see a frequency on TR that sometimes
> follows the radio but is off by a few KHz. The radio follows a direct freq
> entry in TR (every time) but the freq readout in TR does not update nor does
> the band update.
>
> Any ideas?
>
> Mike W9RE
> -----Original Message-----
> From: Trlog [mailto:trlog-bounces@contesting.com] On Behalf Of Mike Wetzel
> Sent: May 21, 2013 12:04 PM
> To: Trlog@contesting.com
> Subject: [Trlog] TR Baud Rate
>
> Is anyone using TR with a baud rate of 9600 or higher? I can't seem to get
> 9600 to work and wondering if it is my computer, serial card or TR. I am
> trying to get a PigKnob to work with a K3 and TR, and the PigKnob only goes
> down to 9600.
>
>
>
> Thanks,
>
>
>
> Mike W9RE
>
>
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|