Amps
[Top] [All Lists]

Re: [Amps] re interfacing IC-706 to alpha 9500

To: "Joe Subich, W4TV" <lists@subich.com>
Subject: Re: [Amps] re interfacing IC-706 to alpha 9500
From: David Gow <6146guy@gmail.com>
Date: Wed, 13 Nov 2019 16:32:39 -0800
List-post: <mailto:amps@contesting.com>
It only matters if you are using cw qsk.  If  you are using vox control for
cw or ssb or a ptt/foot switch the switching time already creates the
delay. The voltage and current levels are fine.
Dave W7VM

On Wed, Nov 13, 2019 at 5:44 AM Joe Subich, W4TV <lists@subich.com> wrote:

>
>  > can I safely use that without anything else in line?
>
> The IC-706 is one of those transceivers that produce RF *AFTER*
> the HSEND line is released.  You will need a timing circuit to
> hold the PTT to your amplifier closed for 5-10ms after HSEND
> goes high.
>
> I've seen documentation from an N0 (scope pictures) and a circuit
> from AD5X <http://www.ad5x.com/images/Articles/QSKDelayRevA.pdf>
>
> 73,
>
>     ... Joe, W4TV
>
>
> On 2019-11-12 10:52 PM, Fern Rivard wrote:
> > I want to interface my Icom IC-706 M II G to my alpha 9500 amplifier.
> > I have the OPC-599 adapter cable c/w an eight pin male plug to into the
> > ACC2 connector.
> > Which option should I use on ACC2,  pin #3 Hsend or pin #6 Vsend and can
> > I safely use that without anything else in line?
> > 73 from Fern  VE7GZ
> >
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>