Looking for a mold that can be used to connect three (3) 2/0 concentric copper cables to a 3/4 Inch copper clad rod. Does this exist? 73 Martin Flynn _______________________________________________ _
Thanks - Cables are 2/0 and the rods are 3/4 inch Have about 12 connections to make, might even be worth it as a custom mold to avoid putting 90 degree bends in the tower to ring cables. Have email o
Reply from NVENT: I suggest using the GRC182G or the GYR182G molds as alternate. Implies being unable to do this in a single weld. Local substation electrician suggested https://shopalltec.com/ge
Hi Folks, Have a project underway for an NPO that we need assistance on: Our team is deploying a VHF AZ/EL mount. It has a need to be as close to another system in appearance as possible Link: http
Actually it does - Do you want your 30 foot Rohn 25 tower bracketed to your house classified by the same rules as a cell / pcs or Commercial two-way tower? Ron, WV4P Are there any good examples out
Have a project underway & needs a quote on a ROHN 25G 20 Foot Self Supporting Tower kit (SKU 25SS020) with the 25AG2 top section Single antenna: Scala CL-FM/HRM Suggestion on sourcing an RFP with
Jorge, All of the manufacturers have right-angle connectors for space-restricted configuration. Avoids use of adapters entirely . Using RG-400 as an example: https://www.l-com.com/coaxial-type-n-mal
Looking to source #6 copperweld for a longwire antenna in less than the standard 685 foot coil. Anyone aware of a source for this product by the foot or 1/2 coil? 73 Martin W2RWJ ____________________
John, Plenty of experience with Copperweld In this case I am looking at a span distance of about 290 feet. Winter Ice and trees dropping branches have snapped #14 CW, so I'm upping the game. Should
If I was to place a wire antenna approximately 300 feet long atop a cyclone fence (on fiberglass pole standoffs) , what's the minimum vertical separation needed? 73, Martin Flynn W2RWJ ______________
N4VOS Sent from my iPhone https://www.wb0w.com/tower_insulators VY 73 Martin Flynn W2RWJ _______________________________________________ _______________________________________________ TowerTalk mail
N4vos Sent from my iPhone If you have access to a decent lathe, this might be an option for raw material: https://www.ebay.com/itm/284480076705? Problem is that you will chew up a bunch of carbide i
Another option: https://www.chromalox.com/en/products-and-technologies/component-technologies/cartridge-and-insertion-heaters/specialty-cartridge-heaters/edison-base-cartridge-heaters Ratings from 50
Have a situation where a UL listed protector is required on a ladder line feeder. Im striking out in my search Any suggestions? 73 Martin W2RWJ _______________________________________________ _______
Appreciate the tips and guidance - here's as much information as I'm comfortable posting. Station is located in a building owned by a unit of government, their insurance vendor requires UL452 / UL 14
Jim, I asked our municipal POC to source a list of protectors that pass the insurance companies muster, here's a link to what was provided https://www.polyphaser.com/Themes/polyphaser/Content/assets