Reply from NVENT: I suggest using the GRC182G or the GYR182G molds as
alternate. Implies being unable to do this in a single weld.
Local substation electrician suggested https://shopalltec.com/gey-mold/ ;
He is going to loan me the clamp to hold the ring cable while welding
(once the exothermic reaction starts, it often cuts the cable before the
weld solidifies)
Ring cable is the lower pair, the cable to the tower is the upper.
73 Martin Flynn
On 8/13/2023 1:00 PM, Martin A. Flynn wrote:
Thanks - Cables are 2/0 and the rods are 3/4 inch
Have about 12 connections to make, might even be worth it as a custom
mold to avoid putting 90 degree bends in the tower to ring cables.
Have email out to Harger and Thermoweld
73 Martin Flynn
On 8/13/2023 12:49 PM, Dave (NK7Z) wrote:
https://www.kf7p.com/KF7P/HargerUniShot.html
73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist, RFI
ARRL Asst. Director, NW Division, Technical Resources
On 8/13/23 07:42, Martin A. Flynn wrote:
Looking for a mold that can be used to connect three (3) 2/0
concentric copper cables to a 3/4 Inch copper clad rod.
Does this exist?
73 Martin Flynn
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|