Re: [TowerTalk] Exothermic welding mold

["Martin A. Flynn" <maflynn@theflynn.org>]

Thanks - Cables are 2/0 and the rods are 3/4 inch

Have about 12 connections to make, might even be worth it as a custom 
mold to avoid putting 90 degree bends in the tower to ring cables.
Have email out to Harger and Thermoweld

73 Martin Flynn

On 8/13/2023 12:49 PM, Dave (NK7Z) wrote:
> https://www.kf7p.com/KF7P/HargerUniShot.html
>
> 73, and thanks,
> Dave (NK7Z)
> https://www.nk7z.net
> ARRL Volunteer Examiner
> ARRL Technical Specialist, RFI
> ARRL Asst. Director, NW Division, Technical Resources
>
> On 8/13/23 07:42, Martin A. Flynn wrote:
> > Looking for a mold that can be used to connect three (3) 2/0 
> > concentric copper cables to a 3/4 Inch copper clad rod.
> > Does this exist?
> >
> > 73 Martin Flynn
> >
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk