THX Stuart,
Power meter shows pretty good output. I think the meter is simply binding and I
think it was dropped in shipping. I noticed that it does not return to zero
when the power is turned off. ALC light flickers when you first transmit but
does not stay on.
I already had to fix a break where the MIC jack connects to the PCB.
Do you know a source for TT technical manuals? How do you remove and replace
the meter? I got the logic counter display board out but can't see how to get
the meter out.
73,
Jim
-----Original Message-----
>From: Stuart Rohre <rohre@arlut.utexas.edu>
>Sent: Jul 22, 2015 5:00 PM
>To: tentec@contesting.com
>Subject: Re: [TenTec] Scout problems
>
>There are a number of diodes in the Scout concerned with SWR measurement
>and others for ALC. Check ALL diodes. ALC light should NOT stay on solid.
>
>Help is just a phone call away to Ten Tec beyond that.
>As long as you are inside the radio, unplug and replug all connecting
>cables to freshen the "bite' of the connector on clean metal. Do these
>one at a time.
>
>Also, you may have driver or finals problems. Check for gross problems
>like a short at the finals or driver.
>
>You did get the manual? For the schematic? If not contact TT.
>
>GL, 73,
>Stuart Rohre
>K5KVH
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|