Floyd -
I have the Orion connected to LP-Pan via the 9MHz IF in the main
receiver. It works acceptably but has odd dips in the display around
the selected frequency. They vary depending on the roofing filter
selected. Most folks aren't bothered by this and the dips are
eliminated if you have the hardware noise blanker on. But, I wanted
better, like I have with my K3 and LP-Pan.
I bought the RX-366 and used it with my LP-Pan with these results:
- no dips, but a hump in the display near the selected frequency.
- a significant spike on the display about 11 kHz below the selected
frequency.
- the RX frequency is that of the sub receiver so you have to have the
sub-receiver track the main receiver for point and click QSY. N4PY
software can handle that for you.
Nothing is perfect. In the end I could tolerate the shortcomings of the
9MHz main receiver IF better than the RX-366 issues and returned the RX-366.
You may feel differently.
73 de K1ESE
John
On 2/13/2014 12:34 PM, Floyd Sense wrote:
Barry - do you know if the output level of the RX366 if different from
what you get when using the IF tap point on the main receiver? I've
been using LP-Pan/NaP3 fed from a tap on the main receiver through the
Clifton Labs buffer amp. I set the gain on that buffer to either 3 or
6 dB when I built it and that's proven to be a good level. I have the
newer LP-Pan with the preamp, but I run with it off as the additional
gain just isn't needed. If I had built the buffer with zero dB gain,
the preamp may have been useful.
73, Floyd - K8AC
On 2/13/2014 12:00 PM, tentec-request@contesting.com wrote:
From: Barry N1EU<barry.n1eu@gmail.com>
To: Discussion of Ten-Tec Equipment<tentec@contesting.com>, Orion565
<orion565@yahoogroups.com>
Subject: [TenTec] Anyone using LP-PAN with Orion/RX366?
Message-ID:
<CAFmfzDtxjo_uZrDSGxKe35sULpjn4GZBtMzB4UaK7jZHQpaNZA@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8
Is anyone out there successfully using LP-PAN pan adapter with the
9MHz output of the RX366 subreceiver? Are you using a buffer amp on
the if output or using the optional add-on LP-PAN preamp (as suggested
by John Henry)? Any other comments/tips appreciated.
Thanks & 73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|