TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[TenTec] Omni C parts

from [Paul DeWitte] [Permanent Link][Original]
To: <tentec@contesting.com>
Subject: [TenTec] Omni C parts
From: "Paul DeWitte" <k9ot@yousq.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 13 Feb 2014 11:30:13 -0600
List-post: <mailto:tentec@contesting.com> 
I am looking for a board # 80708 control board for my 546 Omni C.

Anyone out there with a parted out rig with with an 80708 board?

Thanks,73
Paul
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Omni C parts, Paul DeWitte <=
Previous by Date:  [TenTec] Ten Tec Centaur 411 10m Mod Needed, Doug Ellmore Sr.
Next by Date:  [TenTec] Anyone using LP-PAN with Orion/RX366?, Floyd Sense
Previous by Thread:  [TenTec] Ten Tec Centaur 411 10m Mod Needed, Doug Ellmore Sr.
Next by Thread:  [TenTec] Anyone using LP-PAN with Orion/RX366?, Floyd Sense
Indexes:  [Date] [Thread] [Top] [All Lists]