| To: | <TenTec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair |
| From: | "Roy" <royanjoy@ncn.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 21 Sep 2013 09:02:41 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
"I have a model 560 corsair that I will use for CW only. Can I adjust the power amp bias for lower idle current and not cause problems?"You bet. I run my amps at around 6 mA for CW. Efficiency is increased and things run nice and cool. You can just pull amp up into operate with a toggle switch and leave it during a QSO. 73, Roy K6XK _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Comment on Pixel RF PRO-1B with Orion II, jack |
|---|---|
| Next by Date: | [TenTec] The memory keyer in my Orion still cuts off the first dash of the K at the front of my call. I've tried several suggestions but none work. I'm running the 3.0X software. Any other thoughts?, Haney Howell |
| Previous by Thread: | Re: [TenTec] corsair, Rick - DJ0IP / NJ0IP |
| Next by Thread: | Re: [TenTec] Corsair, Lee WA3FIY |
| Indexes: | [Date] [Thread] [Top] [All Lists] |