| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] corsair |
| From: | Spencer <k5gak@powerc.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 19 Sep 2013 14:24:36 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I have a model 560 corsair that I will use for CW only. Can I adjust the
power amp bias for lower idle current and not cause problems?
Are the narrow (500 and 250) filters available? Spencer W1GAK Silver City, NM _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Corsair II - RX trouble, IV3YNB op. Matteo |
|---|---|
| Next by Date: | Re: [TenTec] corsair, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | [TenTec] Corsair II - RX trouble, IV3YNB op. Matteo |
| Next by Thread: | Re: [TenTec] corsair, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |