TenTec
[Top] [All Lists]

Re: [TenTec] Orion II/DX767 Pro Setup

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II/DX767 Pro Setup
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 26 Aug 2012 11:29:44 -0400
List-post: <mailto:tentec@contesting.com>
I used that headset for awhile with my Omni VII and used the default audio settings - i.e., no EQ at all with splendid results on both send and receive and nearly all my work is SSB... still... I cannot yet hear the long CW letters, but that is because I don't practice every day... but I digress... you may want to have a friend listen to you on his receiver, and advise if you can improve your sending audio with a little EQ in the rig. I do employ the bass roll-off feature - and set that to cut it a 200 Hz, which gives the middle frequencies a bit more punch. Whether or not you want to add in a little EQ should be determined by an on air test. I make recordings of my local friends and they can hear for themselves how they sound on my rig, so maybe one of your friends can do that and you be the judge.

The earphone receivers and mic are fairly un-colored and "flat" so I think TT picked a good set of components for it.

Just MY take...

=====================  K8JHR  =========================

On 8/26/2012 8:16 AM, d.e.warnick@comcast.net wrote:

I haven't done anything to the settings in the rig & get excelloent results with great audio reports.


____________________________________________________













  ..

<Prev in Thread] Current Thread [Next in Thread>