TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ option #3 off Freq

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+ option #3 off Freq
From: John Huffman <hjohnc@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 04 Jul 2012 18:45:34 -0400
List-post: <mailto:tentec@contesting.com>
Barry -

True. But knowing if has an oven would lower the expectations for success and, if the alignment already seems daunting, sending it in may be the least frustrating method.

I still say it's worth knowing. Besides, talking the Ten Tec repair often gives me other tips for diagnosis and repair.

73 de K1ESE
John


On 7/4/2012 5:39 PM, Barry N1EU wrote:
Even if it has an oven, the oven could be bad or the oven still could be
good, ja?  Why not just try to align it?


On Wed, Jul 4, 2012 at 8:57 PM, John Huffman <hjohnc@gmail.com> wrote:

Paul -

I had to send mine into Ten Tec since the old xtal oven was shot and
they replaced it with the newer TCXO.

You might call them with the serial number to see if yours has the oven
before trying to align the radio.

73 de k1ESE
John


On 7/4/2012 4:40 PM, Barry N1EU wrote:
If you are experienced aligning older radios (and prepared for snafu's
that
occasionally happen), I would suggest first aligning the bfo oscillators
(described in the manual under TX Audio Board) and then perform the TCXO
calibration described at http://tentecwiki.org/doku.php?id=563calibrate

>From my own experience, sometimes the trimmer caps need replacing and
sometimes the TCXO calibration is tricky.

It is arguable that the sensible option is to send it into the Ten-Tec
service department.

73/GL,
Barry N1EU

On Wed, Jul 4, 2012 at 7:42 PM, Paul A. Ramey <wg0g@arrl.net> wrote:

Hello to all of you on the list.  I picked up a Omni VI+ option #3 a few
weeks ago.  Radio works great and is loaded with filters for CW and SSB.
I found that the radio is off freq by plus 0.07 in USB and LSB.  I have
been able to correct this by turning on the RIT/XIT.
How can I correct the difference from what the read out is and the real
freq?

BTW I like this radio better that the FT-1000MP that I sold.  The
Ten-Tec , I just like a lot better.  Should not have waited so long to
buy one.

Thanks

Paul, WG0G
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>