What is a TMP cable??
Special?
Standard?
Thanks,
Lee
-----Original Message-----
From: Zivney, Terry <00tlzivney@bsu.edu>
To: tentec <tentec@contesting.com>
Sent: Sat, Feb 11, 2012 4:18 pm
Subject: [TenTec] RX366 IF output and roofing filters
The IF output on theRX366 subreceiver is the TMP next to roofing filter
F2; it
is marked
with 15 in a circle next to the TMP connector. On the connector board
on the
back panel,
the spare RCA jack is connected to the empty TMP jack (next two others
with
coaxes
labled 3 and 4).
I had purchased a 500 Hz roofing filter from INRAD during their annual
New
Year's
day sale - $20.12 off. There is a little piece of paper saying that if
the
filter functions in
only one direction, so if the radio doesn't work, turn the filter
around. The
RX366 board
shows terminals 3 & 4 on the roofing filters are grounded; the INRAD
filters
have a
wide PC trace on the pins 3 & 4 which connect to the grounded terminals
on the
rig.
I bought my TMP cable from INRAD when I ordered my roofing filter.
Terry Zivney, N4TZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|