| To: | "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] OMNI D ser B low power output--still no joy |
| From: | "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 11 Feb 2012 23:11:16 +0100 |
| List-post: | <mailto:tentec@contesting.com> |
What is the voltage of your power supply? What are you measuring voltage with? VOM, VTVM, digital volt meter? Sounds like the meter may just be a little off. A scope would sure be handy right now. 73 Rick -----Original Message----- From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] On Behalf Of scottsheppard@videotron.ca Sent: Saturday, February 11, 2012 11:02 PM To: tentec@contesting.com Subject: [TenTec] OMNI D ser B low power output--still no joy 4 volts at tD _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] OMNI D ser B low power output--still no joy, scottsheppard |
|---|---|
| Next by Date: | Re: [TenTec] RX366 IF output and roofing filters, kc9cdt |
| Previous by Thread: | [TenTec] OMNI D ser B low power output--still no joy, scottsheppard |
| Next by Thread: | [TenTec] OMNI D ser B low power output--still no joy, scottsheppard |
| Indexes: | [Date] [Thread] [Top] [All Lists] |