Re: [TenTec] Model 963 questions

[Carl Moreschi <n4py2@earthlink.net>]

I have been using an Astron 35M for my main supply since 1987.  It has 
been on constantly since then except for when I shut things down for storms.
The supply has never had any RFI problems and has performed flawlessly 
here for 24 years.


Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 9/22/2011 4:27 PM, Mike Hyder -N4NT- wrote:
> Could be you're right. But those things have been around for a long time and
> a lot of them left the factory unsuitable for use in an RF environment. If
> it applies, there it is. If not, no harm, no foul.
>
> Mike N4NT
>
> ----- Original Message -----
> From: "Richards"<jruing@ameritech.net>
> To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
> Sent: Thursday, September 22, 2011 3:53 PM
> Subject: Re: [TenTec] Model 963 questions
>
>
> > I understood from reading elsewhere that particular problem had been
> > resolved with a circuit revision.
> >
> > THANKS for the uptake.
> >
> > ------------------
> > Happy Trails.
> > =======================  Richards / K8JHR  =========================
> >
> > On 9/22/2011 07:23, Mike Hyder -N4NT- wrote:
> > > There have been troubles reported in the past with the Astron RS-35 due
> > > to
> > > RF energy entering the unit. I do not know if newer models have
> > > eliminated
> > > that but here's what they said ten years ago.
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec