TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] NEC, ground, grounds, and radials.

from [Steve Hunt] [Permanent Link][Original]
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] NEC, ground, grounds, and radials.
From: Steve Hunt <steve@karinya.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 08 Jan 2011 12:34:06 +0000
List-post: <mailto:tentec@contesting.com> 
Jerry,
I think I had one of the curve "smoothing" options invoked on the spreadsheet graphing - that may account for it! 

73,
Steve G3TXQ


On 07/01/2011 23:14, Dr. Gerald N. Johnson wrote:


What's that? a kink in the actual or is that because your horizontal
axis is linear and mine is logrithmic (as are most references)? ;<)

73, Jerry, K0CQ
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] New and Improved Terminology, Paul Christensen
Next by Date:  Re: [TenTec] NEC, ground, grounds, and radials., Steve Hunt
Previous by Thread:  Re: [TenTec] NEC, ground, grounds, and radials., Dr. Gerald N. Johnson
Next by Thread:  Re: [TenTec] NEC, ground, grounds, and radials., Rsoifer
Indexes:  [Date] [Thread] [Top] [All Lists]