Used a small roof tower for several years with 22' of aluminum out of it and
a #10 wire to the ground. Fed with twinlead via a Johnson box and worked
all over. Pretty much anything I could hear. Clean and relatively steath as
the aluminum was camo painted so it would disappear against the trees behind
it.
Mike, k5wmg
Pipe Creek, Texas
Green cars, slow boats, big dogs, old trucks, little radios, and summers off
to write
On Wed, Jan 5, 2011 at 11:28 AM, jerome schatten <romers@shaw.ca> wrote:
> I will confirm Rick's results. Almost the same antenna here -- 30 ft of
> tower insulated from ground on my sun deck with a 24 ft aluminum rod
> insulated from the top of the tower; the rod fed against the tower with
> ladder line.
>
> A non-resonant, non symmetrical, vertical dipole -- works 80 thru 10
> with an old Johnson Matchbox. Works everything I can hear and I can hear
> plenty.
>
> Jerome - VA7VV
> Vancouver
>
> On Wed, 2011-01-05 at 11:58 -0500, Rick - NJ0IP / DJ0IP wrote:
> > Jerry, let me throw two things at you:
> >
> > 1. I think a horizontal loop is a pretty good radiator, straight up.
> >
> > 2. The vertical dipole antenna I've described has been in use here for
> > nearly 20 years, at 3 different home QTH's and countless portable
> > operations. On 80m where one would think it is too short to work, I
> found
> > that I was always just as loud working stateside, JA, or VK, etc. on the
> > short vertical dipole, as I was on my full size horizontal dipole which
> was
> > only 40 ft. up. Nobody on this earth can convince me I'm wrong because I
> > have a logbook full of QSOs to prove it. (don't forget, I was in Germany)
> >
> > So, if someone tells me they can't get on 80m because they have no room,
> I
> > just say humbug!
> >
> > You can get a good fiberglass pole, 40 ft long, for about $120 from
> > companies like Spiderbeam.
> > You can get 100 ft. of openwire (300 ohm or 450 ohm) for probably $35.
> > Add 40 ft. of copper wire and you have a good 80m antenna (well 80 thru
> 10m
> > antenna).
> >
> > While living in Oklahoma (until last week), I used a bigger version.
> > Using a 60 ft. Spiderbeam pole, I built my vertical dipole with 30' per
> > side.
> > On 80m in CQWW CW with about 800w, I was able to work every dx station
> that
> > came up on the DX cluster, be it in Africa, or anywhere else, with just
> one
> > or two calls.
> >
> > As I said, people highly underestimate how well these antennas work.
> > L.B. Cebik W4RNL (SK) didn't. He too was a fan of the vertical dipole.
> >
> > Actually, the main reason it works so well is because most people use
> > antennas on 80m which are worse! Hi
> >
> >
> > I agree, you should have good success with a vertical mounted on the
> metal
> > building.
> > I've always wanted to try that but never had the building.
> >
> > 73
> > Rick
> >
> >
> > -----Original Message-----
> > From: tentec-bounces@contesting.com [mailto:
> tentec-bounces@contesting.com]
> > On Behalf Of Dr. Gerald N. Johnson
> > Sent: Wednesday, January 05, 2011 11:00 AM
> > To: tentec@contesting.com
> > Subject: Re: [TenTec] New and Improved Terminology (NVIS origins)
> >
> >
> >
> > On 1/5/2011 4:42 AM, Rick - NJ0IP / DJ0IP wrote:
> > > Ken,
> > >
> > > I don't know if the low angle efficiency falls off faster than the high
> > > angle radiation.
> > > I can't remember ever reading that, but I have probably only read "a
> drop
> > in
> > > the bucket" of all there is.
> >
> > Because of extended ground losses, no antenna has strong radiation
> > exactly at the horizon. It can try but that RF gets absorbed.
> > >
> > > I do know that I changed my attitude about verticals since reading
> Rudy's
> > > papers.
> > >
> > > I also know that there is no reason to ever use a vertical with
> > inefficient
> > > ground.
> > > Instead I use a vertical dipole, 30 to 40 ft. overall length, fed in
> the
> > > middle with openwire, and matched with a matchbox inside the shack.
> > > No radials, yet still has fairly good efficiency.
> >
> > Good efficiency on 40 and higher bands, but rotten on 160 where a good
> > center fed dipole would be 240 feet tall.
> > >
> > > I can't imagine why people continue to go with the traditional design,
> > > except for the case that they are willing to lay down a complex ground
> > > system (or 4 elevated radials per band).
> >
> > I have a metal machine shed 48 x 56', I figure a trap vertical at the
> > middle of all that metal won't need longer radials for the low bands to
> > work decently. I've used a trap vertical on a 30' diameter steel grain
> > bin with super results 40 through 10.
> > >
> > > 73
> > > Rick
> > >
> > >
> > A poor ground plane contributes a poor (e.g. resistive) ground in series
> > with the antenna and so while it improves the bandwidth (and often the
> > impedance match), it hurts radiation efficiency. But it gets out better
> > than no antenna at all.
> >
> > 73, Jerry, K0CQ
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|