I would just use the key line on the accesory cable. If my memory is
correct, this is the black female RCA jack omn the acessory cable. This key
line is great for straight keys and external keyers since it does not matter
if the imternal keyer is turned on or not. And this line works for both
keying in CW and PTT in SSB.
Carl Moreschi N4PY
121 Little Bell Dr
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Scott Harwood" <scotthsr@earthlink.net>; "Discussion of Ten-Tec
Equipment" <tentec@contesting.com>
Sent: Thursday, December 23, 2010 6:43 PM
Subject: Re: [TenTec] New Eagle vs. Used Omni VII
> How would YOU terminate the cable at the rear of the rig? Would you
> drill a hole for
> a jack or just run the cable outside the rig and terminate with an
> "in-line" plug? Or some other plan I have not thought of?
>
> ==================== K8JHR ================================
>
> On 12/23/2010 5:39 PM, Scott Harwood wrote:
>> Hey guys. We're hams!
>>
>> How difficult is it to disconnect the cable from the rear plug and run
>> the cable from the front plug back to the rear?
>>
>> Then, when you sell or trade the rig put it back as it was.
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|