| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Centurion 422 |
| From: | <w7ju@cox.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 15 Dec 2010 17:45:55 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I had a 3 500Z Gas and blow a line fuse. Replaced the one tube. On turn on in standby plate voltage is 3100 but show .2 ma plate current. Suggestions? Thanks Ralph W7JU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Paragon II RS-232 noise, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] Centurion 422, pfizenmayer |
| Previous by Thread: | Re: [TenTec] Paragon II RS-232 noise, Tom Mandera |
| Next by Thread: | Re: [TenTec] Centurion 422, pfizenmayer |
| Indexes: | [Date] [Thread] [Top] [All Lists] |