Depending upon what release you are currently running, here is the entire set of
release notes since production start. Let me know directly if you have any
issues installing 1.688 or with the firmware itself.
Version 1.649
Initial Production Release.
Various internal releases, not for beta or public use
Began usage of Flash32 Flash Update Utility (update.exe) for firmware
updates, version 4.12
Handles com ports above 10
Added Eagle as a supported rig to the standard Flash 32 Update Utility
used in TenTec firmware updates
Improved handling of invalid responses from rig. Problem could cause
program block-writes to fail in the Eagle, some resulted in
initializing the boot loader chip memory. May take longer to program
now, but more reliable now
Version 1.682
Cross Band Transmit is now prohibited
Remember NR value upon power up (NR is always forced off on power up,
the value was remembered as zero, now actual user selection is
remembered for the value)
Corrected state of RF Gain upon power up when it’s value was 0
Added zero power setting so that customers can use the rig for code
practice without transmitting
Added QSK UI control (dELAY in CW Ring, 0 = full QSK, 1..100 = approx.
15ms to 2.5seconds Transmit element release)
Added control of bandwidth to the USB CAT interface. (Uses Orion
format. Once set serially, the BW encoder is ignored. Set to 0 via CAT
again to turn off serial over ride of bandwidth. Power Up default is
always BW encoder control)
Corrected MASTER_RESET clear of memories (was not clearing memories
above 15, now all 100 are cleared)
Handle external keyers that erroneously release TX intermittently
during dahs. Added hysteresis on Key Release for 35usec
V1.687
Corrected Main Frequency CAT query, sporadically sending back
incorrect frequency
Corrected Sub Frequency CAT query, was sending back Main frequency prefix
Corrected tuner recall for the band on power-up. Band changes forced
proper tuner settings, only an issue on power up
V1.688
Updated Factory Test Default Values
Note: From a customer point of view, V1.687 and V1.688 have no
functional differences. 1.688 modifies default values for factory test
and alignment only. Customers can use either version without any
differences
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|