Re: [TenTec] (no subject)

["Dr. Gerald N. Johnson" <geraldj@weather.net>]

From the on line Corsair II manual, pin 1 is audio, pin 2 is ground, 
pin 3 is PTT and pin 4 is +v for electret power.
So white goes to 1, 2 gets shield, I'm not sure about black and red. But 
with a model number for the TenTec microphone, there's probably a manual 
on line describing their function.
73, Jerry, K0CQ
On 11/11/2010 11:22 AM, Jim Huicks wrote:
> Thanks, I also need the wiring on a Corsair 2, I have a Ten Tec base mic, wires 
> sheild with white wire, and a red and a black if someone could tell me were 
> they go on the mic connector. Thanks Jim