Thank you all for the nice reply to my questions regarding the HV on the
Centurion.
Richard was nice enough to send me a photo of his 422B showing the 3100 V.
1. I am using 230VAC in the shack. It was just recently installed when
we had to get a new breaker box and 200 amp service installed. The 230V
line was installed by a electrinican.
2. While the PS could be the problem, I think it might be the meter
resistors that have changed value.
3. I am still getting 1300 Watts ouput and no hum or anything like that.
4. I am going to study the manual/diagream a bit more and the next time
I have to open the case on the Centurion I will do some voltage and
resistor test.
5. The reason for the question in the first place was that 3 of us in
our DX club have the exact same 2800 V on our 422 amp.
Thank you again for your suggestions as they were all good.
Joe K0BX
Top-Of-The-Honor Roll Mixed
Richards wrote:
My fairly new example indicates at least 3100 V when I
use the Ep meter reading. Does this help, or did I
not get the correct setting?
|