I was mistaken (I'll defer to Carl who writes the firmware) regarding
Paragon II clocks being programmable. I misspoke; I had a 585 Paragon, not
the Paragon II. The clocks in the 585 were Motorola chips the DST problem.
(And they changed UTC just like it was local time).
73,
Gary - AB9M
--------------------------------------------------
From: "DAVID HELLER" <dtx@verizon.net>
Sent: Tuesday, March 03, 2009 12:04 AM
To: "N4PY" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Subject: Re: [TenTec] Paragon II
Just leave the clock set at UTC. Who needs local time in the shack.
K3TX
----- Original Message -----
From: "N4PY" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 02, 2009 10:26 PM
Subject: Re: [TenTec] Paragon II
I wrote the firmware for the Paragon II. The clock chip is programmable
with a daylight savings time option bit. This setting is always turned
off
in the Paragon II. So the Paragon II will never change its clock for
DST.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "CSM(r) Gary Huber" <glhuber@msn.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 02, 2009 8:47 PM
Subject: Re: [TenTec] Paragon II
Clock "problem" may be the daylight saving time spring advance and and
fall back times that are "hard coded" to execute based upon advancing
the
time one hour at 0100 the last Sunday in April and to fall back one hour
at 0200 the last Sunday in October. This was verified (by me) during
research for the Millennium rollover. The clock chip is a Motorola IC
with
no options to deactivate the advance and set back.
I'm a previous owner of a Paragon II. Great radio.... just run a
separate
clock for logging!
Best regards,
CSM(r) Gary Huber - AB9M
9679 Heron Bay Rd
Bloomington, IL 61705
(309-662-0604)
www.csm-gh.com
glhuber@msn.com
gary.huber@us.army.mil
--------------------------------------------------
From: "peter" <w8us@comcast.net>
Sent: Monday, March 02, 2009 6:06 PM
To: <tentec@contesting.com>
Subject: [TenTec] Paragon II
Tentec Paragon II station for sale. Model 586. This is a highly
desirable Paragon II model and is considered an equivalent to higher
priced transceivers today. It has all the available filters installed
and is supplied with the matching Tentec 961 power supply/speaker and
Tentec desk mike. Also, the original boxes and manual are available.
The station was operated in a non-smoking environment. The receiver is
general coverage, 300 Khz to 30 Mhz. Modification to allow the
transmitter to operate between 1.8 and 30 Mhz has been made, thus it
covers the new 60 meter band.
Equipment is in excellent cosmetic and mechanical condition and has no
scratches. The station clock is erratic at times, but this does not
affect the operation of the transceiver.
Will consider selling Paragon II by itself.
If you are a C.W. operator, this is your dream set-up. Price $900.00
shipped and insured to lower 48 only. Contact Peter, W8US, at
W8us@comcast.net.
Peter
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|