Have you tried a master reset?
Dell R Smith
Prosser,Wa
KI7XD DN-06
OMNI VI Opt1
--- On Sun, 6/29/08, Hamdriver66@aol.com <Hamdriver66@aol.com> wrote:
> From: Hamdriver66@aol.com <Hamdriver66@aol.com>
> Subject: [TenTec] Omni VI S-Meter
> To: tentec@contesting.com
> Date: Sunday, June 29, 2008, 8:48 PM
> I have a problem that has just developed with my Omni VI,
> option 1, with the
> S-meter. All has been working well until a few nights ago.
> I switched the
> rig on and noticed the S-meter was nearly pegged out in the
> receive mode,
> with the meter switch in the "fwd" position.
> Tried reducing RF gain, engaging
> attenuator, changing filter settings, all of which made no
> difference. Cycled
> the rig to transmit and back to recieve several times, and
> the needle stayed
> near the top end of the scale the whole time. If I move
> the meter switch to
> "swr" or other positions it reads incoming signal
> strength normally and
> functions as it should. This is on all bands on any
> antenna or dummy load. Removed
> the top cover, inspected wiring around the meter switch
> and cleaned switch
> with Deoxit. Still have the problem. Has anyone else
> seen this occur, looking
> for ideas as to a cause. Any help will be appreciated.
> Thanks. Mike K4KJC.
>
>
>
>
> **************Gas prices getting you down? Search AOL Autos
> for
> fuel-efficient used cars.
> (http://autos.aol.com/used?ncid=aolaut00050000000007)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|