TenTec
[Top] [All Lists]

Re: [TenTec] feeding audio to rear acc on Orion II

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] feeding audio to rear acc on Orion II
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 3 Jun 2008 08:03:39 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The mic preamp, which contains an audio AGC is bypassed.  The AGC actually 
works pretty good and uses the same chip as the W2IHY EQplus.   If you have 
an external processor with high level output, feeding into the back is a 
good idea, but not a whole lot is gained or lost going through the mic 
connector on the front.  Both have good frequency response and low noise. 
The advantage of using the internal preamp and AGC is that the level going 
into the analog to digital converter is kept from driving it to distortion.

         Ron  N6IE
      www.N6IE.com


----- Original Message ----- 
From: "markinkpt" <markinkpt@hotmail.com>
To: <tentec@contesting.com>
Sent: Tuesday, June 03, 2008 6:03 AM
Subject: [TenTec] feeding audio to rear acc on Orion II


> What are the advantages of feeding mic gear through the rear acc plug as 
> opposed going through the front mic connector? What is bypassed?
>
> Thanks,
> Mark ka4ick
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>