Follow up:
If you have a PLL problem you will either hear all CW signals warbly or
unstable. This instability is caused by poor solder joints on the PLL
boards. If the PLL is actually not locking, you will get no receive at
all and the display will spell out, "PLL OUT OF LOCK". A out-of-lock
condition can be either solder related or it may just need a small
adjustment to the VCO coil on the offending band.
73,
Bob WB2VUF
john ferro wrote:
hi everyone, i just picked up a paragon I - the guy i purchased it from said it
had a PLL unlock error, but that the radio worked - so far i get no error and
the radio receives wonderfully. i just wired up my shure 444d mic to be used
with this radio and when i key the mic a funny symbol next to the freq. display
comes on - it looks like an E turned on its back with three lines (rays?)
coming out of the bottom of the E - is this the PLL error message? also after
keying the mic there is a slight delay before returning to receive mode? when
the radio returns to receive mode the symbol goes away - i was thinking i have
the mic wired wrong - but it seems to be keying the radio - has anyone ever
seen this - there is no reference to this in the paragon manual. thanks again
for all your time - i have learned a great deal about ten tecs here and i
appreciate all the expert commentary.
sincerely, john
_________________________________________________________________
Need to know the score, the latest news, or you need your Hotmail®-get your
"fix".
http://www.msnmobilefix.com/Default.aspx
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|