I remember reading, a long time ago, that the Heils used to be 200 ohms but
they were later changed to be lower impedance. Heil could confirm that.
When I use my $300 Bose Quiet Comfort 2 headphones after using my ProSet
Plus, I have to reduce the volume LOTS on any radio. That's with the Bose
in the Hi output position; in the Lo position I need increase the volume. I
don't know their respective impedances.
Jim N7US
-----Original Message-----
FWIW, for 4 years my v1 Orion I/Heil Pro Set (200 ohms) combo has been
100% consistent in my ability to just set AF Gain at 50% and vary RF
Gain till I can just hear the band noise. This has always given
excellent AF/RF level in all conditions. This only applies to v1
firmware.
73,
Barry N1EU
On Jan 15, 2008 10:54 PM, Duane Calvin <ac5aa1@gmail.com> wrote:
> My Orion 1 has the same problem reported in the original posting. I have
to
> run the AF gain at about 75% when driving my Heil ProSet.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|